Siemens SINUMERIK 810D User Manual

2
Operator Components/Sequence of Operations 03.04
2.8 Job list
2
Ó Siemens AG, 2004. All rights reserved
2-78 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
2.8 Job list
Function
With SW 5 and higher, it is possible to create a job list (loading list) for
each workpiece.
This list contains instructions which prepare the following for the
execution of part programs (in several channels if necessary):
· Parallel setup (LOAD/COPY) i.e.:
Load or copy main programs, subroutines and associated data
such as
- Initialization programs (INI)
- R parameters (RPA),
- User data (GUD),
- Work offset (UFR),
- Tool/magazine data (TOA/TMA),
- Setting data (SEA),
- Protection zones (PRO) and
- Sag/angularity (CEC)
from the hard disk of the HMI to the NC user memory.
· Preparations for the NC Start (SELECT) i.e.:
Select programs in different channels as well as starting
preparations for execution
· Parallel clearing (reversed LOAD/COPY) i.e.:
Remove/unload main programs, subroutines and associated data
from the NC working memory to the hard disk of the HMI
· Backup (in preparation for the next software version)
Notes
Parallel setup, preparations for NC Start, parallel cleanup and backup
can also be executed from the PLC.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English