Siemens SINUMERIK 810D User Manual

2
Operator Components/Sequence of Operations 03.04
2.8 Job list
2
Ó Siemens AG, 2004. All rights reserved
2-88 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
2.8.6 Copy workpieces with job lists
This function applies to operating area "Program" only.
When you copy under "Services", the names remain unchanged.
Operating sequence
Manage
programs
The softkey "Manage programs" in the "Program" operating area must
be pressed.
Copy
Position the cursor on the file that you want to copy and press the
softkey "Copy".
The file is marked as the source for copying.
Insert
OK
Press the softkey "Insert", specify another name if required
and confirm with "OK".
2.8.7 Archive workpieces with job lists in case of m:n
Function
When archiving workpieces that contain job lists of the same name, in
the case of m:n you are asked whether the job lists to be unloaded
are to be executed. You can terminate the action with "Cancel",
otherwise all joblists are executed and archiving is then started.
Operating sequence
Data
from
In the "Services" operating area press the "Data from" softkey. The
"Programs/Data" file tree is displayed.
The vertical softkey bar changes.
Please refer to Chapter "Reading out data" in "Services" operating
area for additional sequences of operation.
n

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English