AudioCodes Mediant 3000 User Manual

Version 7.0 1007 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
(due to a previous 183 early media response or due to an SDP
in the current 180 response), the device plays a local ringback
tone if there are no prior received RTP packets. The device
stops playing the local ringback tone as soon as it starts
receiving RTP packets. At this stage, if the device receives
additional 18x responses, it does not resume playing the local
ringback tone. Note that for ISDN trunks, this option is
applicable only if LocalISDNRBSource is set to 1.
Notes:
 The parameter is applicable only to the Gateway (GW)
application.
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Play Ringback Tone to IP
[PlayRBTone2IP]
Global parameter that enables the device to play a ringback tone to
the IP side for IP-to-Tel calls. You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_PlayRBTone2IP). For a detailed description of the
parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 391.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
Play Local RBT on ISDN
Transfer
[PlayRBTOnISDNTransfer]
Determines whether the device plays a local ringback tone for
ISDN's Two B Channel Transfer (TBCT), Release Line Trunk
(RLT), or Explicit Call Transfer (ECT) call transfers to the originator
when the second leg receives an ISDN Alerting or Progress
message.
 [0] Don't Play (default)
 [1] Play
Notes:
 For Blind transfer, the local ringback tone is played to first call
PSTN party when the second leg receives the ISDN Alerting or
Progress message.
 For Consulted transfer, the local ringback tone is played when
the second leg receives ISDN Alerting or Progress message if
the Progress message is received after a SIP REFER.
 The parameter is applicable only if the parameter
SendISDNTransferOnConnect is set to 1.
MFC R2 Category
[R2Category]
Defines the tone for MFC R2 calling party category (CPC). The
parameter provides information on the calling party such as
National or International call, Operator or Subscriber and
Subscriber priority.
The value range is 1 to 15 (defining one of the MFC R2 tones). The
default is 1.
58.10.9.2 Tone Detection Parameters
The signal tone detection parameters are described in the table below.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English