Version 7.0 673 Mediant 3000
User's Manual 42. High Availability Maintenance
42 High Availability Maintenance
This section describes various maintenance procedures for the High Availability mode.
42.1 Initiating an HA Switchover
You can initiate a switchover from the Active unit to Redundant unit.
Note:
When performing an HA switchover, the HA mode becomes temporarily
unavailable.
 To perform a switch-over:
1. Open the High Availability Maintenance page:
• Navigation menu tree: Maintenance tab > Maintenance menu > High
Availability Maintenance
• Toolbar: Click the Device Actions button, and then choose Switch Over
Figure 42-1: High Availability Maintenance Page
2. Under the 'Switch Over' group, click Switch Over; a confirmation box appears
requesting you to confirm.
3. Click OK.
42.2 Resetting the Redundant Unit
You can reset the Redundant unit, if necessary.
Note:
When resetting the Redundant unit, the HA mode becomes temporarily
unavailable.
 To reset the Redundant unit:
1. Open the High Availability Maintenance page:
• Navigation menu tree: Maintenance tab > Maintenance menu > High
Availability Maintenance
To Next Page
Loading...
Need help?
General
