User's Manual 112 Document #: LTRT-89730
Mediant 3000
9.5 Configuring SNMP V3 Users
The SNMPv3 Users table lets you configure up to 10 SNMP v3 users for authentication
and privacy.
The following procedure describes how to configure SNMP v3 users through the Web
interface. You can also configure it through ini file (SNMPUsers).
 To configure an SNMP v3 user:
1. Open the SNMPv3 Users table (Configuration tab > System menu > Management >
SNMP > SNMP V3 Users).
2. Click Add; the following dialog box appears:
Figure 9-4: SNMPv3 Users Table - Add Row Dialog Box
3. Configure the SNMP V3 parameters according to the table below.
4. Click Add, and then save ("burn") your settings to flash memory.
Note: If you delete a user that is associated with a trap destination (see ''Configuring
SNMP Trap Destinations'' on page 110), the configured trap destination becomes
disabled and the trap user reverts to default (i.e., SNMPv2).
Table 9-3: SNMPv3 Users Table Parameters Description
Parameter Description
Index
[SNMPUsers_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
User Name
[SNMPUsers_Username]
Name of the SNMP v3 user. This name must be unique.
Authentication Protocol
[SNMPUsers_AuthProtocol]
Authentication protocol of the SNMP v3 user.
 [0] None (default)
 [1] MD5
 [2] SHA-1
Privacy Protocol Privacy protocol of the SNMP v3 user.
To Next Page
Loading...
Need help?
General
