AudioCodes Mediant 3000 User Manual

Version 7.0 923 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
TelProfile_FlashHookPeriod, TelProfile_EnableEarlyMedia,
TelProfile_ProgressIndicator2IP, TelProfile_TimeForReorderTone,
TelProfile_EnableDIDWink, TelProfile_IsTwoStageDial,
TelProfile_DisconnectOnBusyTone, TelProfile_EnableVoiceMailDelay,
TelProfile_DialPlanIndex, TelProfile_Enable911PSAP,
TelProfile_SwapTelToIpPhoneNumbers, TelProfile_EnableAGC,
TelProfile_ECNlpMode, TelProfile_DigitalCutThrough,
TelProfile_EnableFXODoubleAnswer, TelProfile_CallPriorityMode;
[\TelProfile]
For a description of the parameter, see Configuring Tel Profiles on page
388.
58.9 Channel Parameters
This subsection describes the device's channel parameters.
58.9.1 Voice Parameters
The voice parameters are described in the table below.
Table 58-37: Voice Parameters
Parameter Description
Input Gain
[InputGain]
Global parameter that defines the pulse-code modulation (PCM)
input (received) gain control level (in decibels). You can also
configure this functionality per specific calls, using IP Profiles
(IpProfile_InputGain) or Tel Profiles. For a detailed description of
the parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 391 or in the Tel
Profile table, see Configuring Tel Profiles on page 388.
Note: If this functionality is configured for a specific profile, the
settings of this global parameter is ignored for calls associated
with the profile.
Voice Volume
[VoiceVolume]
Global parameter that defines the voice gain control (in decibels).
This defines the level of the transmitted (IP-to-Tel) signal. You can
also configure this functionality per specific calls, using IP Profiles
(IpProfile_VoiceVolume) or Tel Profiles. For a detailed description
of the parameter and for configuring this functionality in the IP
Profile table, see ''Configuring IP Profiles'' on page 391 or in the
Tel Profile table, see Configuring Tel Profiles on page 388.
Note: If this functionality is configured for a specific profile, the
settings of this global parameter is ignored for calls associated
with the profile.
[VoicePayloadFormat]
Determines the bit ordering of the G.726 voice payload format.
 [0] = (Default) Little Endian
 [1] = Big Endian
Note: To ensure high voice quality when using G.726, both
communicating ends should use the same endianness format.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English