AudioCodes Mediant 3000 User Manual

User's Manual 150 Document #: LTRT-89730
Mediant 3000
Parameter Description

For the parameter to take effect, a device reset is required.
 To enable the Physical Network Separation feature, use the
EnableNetworkPhysicalSeparation parameter.
13.3.1 Assigning NTP Services to Application Types
You can associate the Network Time Protocol (NTP) application with the OAMP or Control
application type. This is done using the EnableNTPasOAM ini file parameter.
13.3.2 Multiple Interface Table Configuration Summary and Guidelines
The Interface table configuration must adhere to the following rules:

Subnets of different interfaces must not overlap (i.e. 10.0.0.1/8 and 10.50.10.1/24 is
invalid); each interface must have its own address space.

The prefix length replaces the dotted-decimal subnet mask presentation and must
have a value of 0-30 for IPv4 addresses and a value of 0-64 for IPv6 addresses.

One OAMP interface must be configured and this must be an IPv4 address. This
OAMP interface can be combined with Media and Control.

At least one Control interface must be configured.

At least one Media interface must be configured.

Multiple Media and/or Control interfaces can be configured with an IPv6 address.

The network interface types can be combined:
• Example 1:
♦ One combined OAMP-Media-Control interface with an IPv4 address
• Example 2:
♦ One OAMP interface with an IPv4 address
♦ One or more Control interfaces with IPv4 addresses
♦ One or more Media interfaces with IPv4 interfaces
• Example 3:
♦ One OAMP with an IPv4 address
♦ One combined Media-Control interface with IPv4 address
♦ One combined Media-Control interface with IPv6 address

Each network interface can be configured with a Default Gateway. The address of the
Default Gateway must be in the same subnet as the associated interface. Additional
static routing rules can be configured in the Static Route table.

The interface name must be configured (mandatory) and must be unique for each
interface.

For IPv4 addresses, the 'Interface Mode' column must be set to IPv4 Manual. For IPv6
addresses, this column must be set to IPv6 Manual or IPv6 Manual Prefix.
Note: Upon device start up, the Interface table is parsed and passes comprehensive
validation tests. If any errors occur during this validation phase, the device sends an
error message to the Syslog server and falls back to a "safe mode", using a single
interface without VLANs. Ensure that you view the Syslog messages that the device
sends in system startup to see if any errors occurred.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English