User's Manual 840 Document #: LTRT-89730
Mediant 3000
Parameter Description
The parameter is applicable only for automatic HTTP update or
Web ini file upload (not applicable if the ini file is loaded using BootP).
[SaveConfiguration] Determines if the device's configuration (parameters and files) is save
to flash (non-volatile memory).
 [0] = Configuration isn't saved to flash memory.
 [1] = (Default) Configuration is saved to flash memory.
Auxiliary and Configuration File Name Parameters
Call Progress Tones File
[CallProgressTonesFilenam
e]
Defines the name of the file containing the Call Progress Tones
definitions.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'cpt_us.dat'.
For more information on how to create and load this file, refer to
DConvert Utility User's Guide.
Note: For the parameter to take effect, a device reset is required.
Prerecorded Tones File
[PrerecordedTonesFileNam
e]
Defines the name of the file containing the Prerecorded Tones.
Note: For the parameter to take effect, a device reset is required.
CAS File
[CASFileName_x]
Defines the CAS file name (e.g., 'E_M_WinkTable.dat'), which defines
the CAS protocol (where x denotes the CAS file ID 0 to 7). It is
possible to define up to eight different CAS files by repeating the
parameter. Each CAS file can be associated with one or more of the
device's trunks, using the parameter CASTableIndex or it can be
associated per B-channel using the parameter CASChannelIndex.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'cas_us.dat'.
Note: For the parameter to take effect, a device reset is required.
Dial Plan
[CasTrunkDialPlanName_x]
Defines the Dial Plan name (up to 11-character strings) per trunk.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan_2.dat'.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Dial Plan File
[DialPlanFileName]
Defines the name of the Dial Plan file. This file should be created using
AudioCodes DConvert utility (refer to DConvert Utility User's Guide).
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan.dat'.
[UserInfoFileName] Defines the name of the file containing the User Information data.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'userinfo_us.dat'.
58.1.8 Automatic Update Parameters
The automatic update of software and configuration files parameters are described in the
table below.
Note: Auxiliary file upload through TFTP is not supported by HA mode.
To Next Page
Loading...
Need help?
General
