User's Manual 848 Document #: LTRT-89730
Mediant 3000
Parameter Description
Note: If this parameter is not configured (i.e., default value is 1) and one
of the interfaces has a VLAN ID set to 1, this interface is still considered
the ‘Native’ VLAN. If you do not wish to have a ‘Native’ VLAN ID and
want to use VLAN ID 1, set this parameter to a value other than any
VLAN ID in the table.
[EnableNTPasOAM] Defines the application type for Network Time Protocol (NTP) services.
 [1] = OAMP (default)
 [0] = Control
Note: For the parameter to take effect, a device reset is required.
[VLANSendNonTaggedOn
Native]
Determines whether to send non-tagged packets on the native VLAN.
 [0] = (Default) Sends priority tag packets.
 [1] = Sends regular packets (with no VLAN tag).
Note: For the parameter to take effect, a device reset is required.
58.2.3 Routing Parameters
The IP network routing parameters are described in the table below.
Table 58-11: IP Network Routing Parameters
Parameter Description
Send ICMP Unreachable
Messages
[DisableICMPUnreachable
]
Enables sending of ICMP Unreachable messages.
 [0] Enable = (Default) Device sends these messages.
 [1] Disable = Device does not send these messages.
Send and Receive ICMP
Redirect Messages
[DisableICMPRedirects]
Enables sending and receiving of ICMP Redirect messages.
 [0] Enable = (Default) Device sends and accepts these messages.
 [1] Disable = Device rejects these messages and also does not send
them.
Static Route Table
Static Route Table
[StaticRouteTable]
Defines up to 30 static IP routes for the device.
The format of the ini file table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]
For a description of the parameter, see ''Configuring Static IP Routes'' on
page 154.
To Next Page
Loading...
Need help?
General
