User's Manual 1010 Document #: LTRT-89730
Mediant 3000
Parameter Description
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Note:To associate a configured Charge Code to an outgoing Tel-to-
use the Tel-to-IP Routing table.
58.10.10 Trunk Groups and Routing Parameters
The routing parameters are described in the table below.
Table 58-65: Routing Parameters
Parameter Description
Trunk Group Table
Trunk Group Table
[TrunkGroup]
Defines and activates Trunk Groups.
The format of the ini file table parameter is as follows:
[TrunkGroup]
FORMAT TrunkGroup_Index = TrunkGroup_TrunkGroupNum,
TrunkGroup_FirstTrunkId, TrunkGroup_FirstBChannel,
TrunkGroup_LastBChannel, TrunkGroup_FirstPhoneNumber,
TrunkGroup_ProfileName, TrunkGroup_LastTrunkId,
TrunkGroup_Module;
[\TrunkGroup]
For a description of the table, seeConfiguring Trunk Groups on page
461.
Note: Trunk Group ID 1 is denoted as 0 in the table.
Trunk Group Settings Table
Trunk Group Settings
[TrunkGroupSettings]
Defines the rules for channel allocation per Trunk Group.
The format of the ini file table parameter is as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,
TrunkGroupSettings_ContactUser,
TrunkGroupSettings_ServingIPGroupName,
TrunkGroupSettings_MWIInterrogationType,
TrunkGroupSettings_TrunkGroupName,
TrunkGroupSettings_UsedByRoutingServer;
[\TrunkGroupSettings]
For a description of the table, see ''Configuring Trunk Group
Settings'' on page 463.
Channel Select Mode Defines the method for allocating incoming IP-to-Tel calls to a
channel. The parameter applies to the following: