AudioCodes Mediant 3000 User Manual

User's Manual 858 Document #: LTRT-89730
Mediant 3000
Parameter Description
SBC Test ID
sbc-test-id
[SBCtestID]
Defines the SBC test call prefix (ID) for identifying SBC test calls that
traverse the device to register with an external routing entity such as an
IP PBX or proxy server.
The parameter functions together with the TestCallID parameter, which
defines the prefix of the simulated endpoint. Upon receiving an incoming
call with this prefix, the device removes the prefix, enabling it to forward
the test call to the external entity. Upon receiving the call from the
external entity, the device identifies the call as a test call according to its
prefix, defined by the TestCallID, and then sends the call to the
simulated endpoint.
For example, assume SBCTestID is set to 4 and TestCallID to 2. If a call
is received with called destination 4200, the device removes the prefix 4
and routes the call to the IP PBX. When it receives the call from the IP
PBX, it identifies the call as
a test call (i.e., prefix 2) and therefore, sends
it to the simulated endpoint.
The valid value can be any string of up to 15 characters. By default, no
number is defined.
Note: This feature is applicable only to the SBC application.
Test Call Table
Test Call Table
[Test_Call]
Defines Test Call rules.
[ Test_Call ]
FORMAT Test_Call_Index = Test_Call_EndpointURI,
Test_Call_CalledURI, Test_Call_RouteBy, Test_Call_IPGroupName,
Test_Call_DestAddress, Test_Call_DestTransportType,
Test_Call_SIPInterfaceName, Test_Call_ApplicationType,
Test_Call_AutoRegister, Test_Call_UserName, Test_Call_Password,
Test_Call_CallParty, Test_Call_MaxChannels, Test_Call_CallDuration,
Test_Call_CallsPerSecond, Test_Call_TestMode,
Test_Call_TestDuration, Test_Call_Play, Test_Call_ScheduleInterval,
Test_Call_QOEProfile, Test_Call_BWProfile;
[ \Test_Call ]
For a description of the table, see ''Configuring Test Call Endpoints'' on
page 811.
58.3.3 Syslog, CDR and Debug Parameters
The Syslog, CDR and debug parameters are described in the table below.
Table 58-20: Syslog, CDR and Debug Parameters
Parameter Description
Enable Syslog
[EnableSyslog]
Determines whether the device sends logs and error messages (e.g.,
CDRs) generated by the device to a Syslog server.
 [0] Disable (default)
 [1] Enable
Notes:
 If you enable Syslog, you must enter an IP address of the Syslog
server (using the SyslogServerIP parameter).
 Syslog messages may increase the network traffic.
 To configure Syslog SIP message logging levels, use the

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English