Version 7.0 967 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
Line Build Out XPM2
[LineBuildOut.XPM2]
Defines the Framer's XPM2 register value (line pulse shape
control).
The range is 0 to 255. The default is 0.
Note: The parameter is applicable only when the parameter
TrunkConfig.LineBuildOut.Overwrite is set to 1.
[TDMHairPinning] Defines static TDM hair-pinning (cross-connection) performed at
initialization. The connection is between trunks with an option to
exclude a single B-channel in each trunk. Format example: T0-
T1/B3,T2-T3,T4-T5/B2.
Note: For the parameter to take effect, a device reset is required.
[TDMHairPinningAlarmIndicatio
n]
Enables two trunks that are connected through TDM hairpinning to
signal the Far-End about the presence of PSTN alarms. When the
trunk with TDM hairpinning receives a PSTN alarm, its' connected
trunk sends an AIS alarm to its' Far-End.
ï‚§ [0] = (Default) Disable
ï‚§ [1] = Enable
Note:
ï‚§ For the parameter to take effect, a device reset is required.
ï‚§ The parameter is applicable only to PRI.
Enable TDM Tunneling
tdm-tunneling
[EnableTDMoverIP]
Enables TDM tunneling.
ï‚§ [0] Disable (default)
ï‚§ [1] Enable
Notes:
ï‚§ For the parameter to take effect, a device reset is required.
ï‚§ For an overview on TDM tunneling, see TDM Tunneling
443.
[ISO8859CharacterSet]
Defines the ISO 8859 character set type (languages) for
representing the alphanumeric string of the calling name (caller ID)
in the forwarded message, for IP-to-Tel and Tel-to-IP calls.
ï‚§ [0] No Accented = Proprietary method where incoming INVITE
messages with any accented characters (e.g., á, é, Ã, ó, and ü),
which are represented in a 2-byte unicode character, are
translated to Latin-only, which are normal one-byte ASCII
characters (a, e, i, o, and u, respectively).
ï‚§ [1] Western European (Default)
ï‚§ [2] Central European
ï‚§ [3] South European
ï‚§ [4] North European
ï‚§ [5] Cyrillic
ï‚§ [6] Arabic
ï‚§ [7] Hebrew
ï‚§ [8] Turkish
58.10.6.2 TDM Bus and Clock Timing Parameters
The TDM Bus and clock timing parameters are described in the table below.