AudioCodes Mediant 3000 User Manual

User's Manual 834 Document #: LTRT-89730
Mediant 3000
Parameter Description
displayed.
58.1.3 Telnet Parameters
The Telnet parameters are described in the table below.
Table 58-3: Telnet Parameters
Parameter Description
Embedded Telnet Server
[TelnetServerEnable]
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.
 [0] Disable (default)
 [1] Enable Unsecured
 [2] Enable Secured
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet (see
''Configuring Web User Accounts'' on page 82).
Telnet Server TCP Port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Telnet Server Idle Timeout
[TelnetServerIdleDisconnec
t]
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default is 0.
Note: For the parameter to take effect, a device reset is required.
Maximum Telnet Sessions
[TelnetMaxSessions]
Defines the maximum number of permitted, concurrent Telnet/SSH
sessions.
The valid range is 1 to 5 sessions. The default is 2.
Note: Before changing the value, make sure that not more than this
number of sessions are currently active; otherwise, the new setting will
not take effect.
58.1.4 ini File Parameters
The parameters relating to ini-file management are described in the table below.
Table 58-4: ini File Parameters
Parameter Description
[INIPasswordsDisplayTy
pe]
Defines how passwords are displayed in the ini file.
 [0] Disable (default) = Passwords are obscured ("encoded"). The
passwords are displayed in the following syntax: $1$<obscured
password> (e.g., $1$S3p+fno=).
 [1] Enable = All passwords are hidden and replaced by an asterisk
(*).

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English