Version 7.0 877 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
The default IP address is 0.0.0.0.
Server Port
[OCSPServerPort]
Defines the OCSP server's TCP port number.
The default port number is 2560.
Default Response When
Server Unreachable
[OCSPDefaultResponse]
Determines whether the device allows or rejects peer certificates
when the OCSP server cannot be contacted.
 [0] Reject (default)
 [1] Allow
58.5 Quality of Experience Parameters
The Quality of Experience (QoE) parameters are described in the table below.
Table 58-32: Quality of Experience Parameters
Parameter Description
SEM Parameters
Server IP
[QOEServerIP]
Defines the IP address of the primary Session Experience Manager
(SEM) server to where the quality experience reports are sent.
Note: For the parameter to take effect, a device reset is required.
Redundant Server IP
[QOESecondaryServerIp]
Defines the IP address of the secondary SEM server to where the quality
experience reports are sent. This is applicable when the SEM/EMS
server is in Geographical Redundancy HA mode.
Note: For the parameter to take effect, a device reset is required.
Port
[QOEPort]
Defines the port of the SEM server.
The valid value range is 0 to 65534. The default is 5000.
Interface Name
[QOEInterfaceName]
Defines the IP network interface on which the quality experience reports
are sent.
The default is the OAMP interface.
Note: For the parameter to take effect, a device reset is required.
QoE Connection by TLS
[QOEEnableTLS]
Enables a TLS connection with the SEM server.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
QOE TLS Context Name
[QoETLSContextName]
Selects a TLS Context (configured in the TLS Contexts table) for the TLS
connection with the SEM server.
The valid value is a string representing the name of the TLS Context as
configured in the 'Name' field of the TLS Contexts table. The default is
the default TLS Context (ID 0).
To Next Page
Loading...
Need help?
General
