AudioCodes Mediant 3000 User Manual

Version 7.0 981 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
where 0 is Trunk 1.
 For more information on NFAS, see ISDN Non-Facility
Associated Signaling (NFAS) on page 448.
D-channel Configuration
[DChConfig_x]
Defines primary, backup (optional), and B-channels only, per trunk.
 [0] PRIMARY= (Default) Primary Trunk - contains a D-channel
that is used for signaling.
 [1] BACKUP = Backup Trunk - contains a backup D-channel
that is used if the primary D-channel fails.
 [2] NFAS = NFAS Trunk - contains only 24 B-channels, without
a signaling D-channel.
Notes:
 The parameter is applicable only to T1 ISDN protocols.
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
NFAS Interface ID
[ISDNNFASInterfaceID_x]
Defines a different Interface ID per T1 trunk.
The valid range is 0 to 100. The default interface ID equals the
trunk's ID.
Notes:
 To set the NFAS interface ID, configure ISDNIBehavior_x to
include '512' feature per T1 trunk.
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
 For more information on NFAS, see ISDN Non-Facility
Associated Signaling (NFAS) on page 448.
58.10.6.5 DS3 Parameters
The DS3 parameters are described in the table below.
Note: DS3 interface is applicable only to Mediant 3000 with TP-6310.
Table 58-58: DS3 Parameters
Parameter Description
DS3 Settings Table
[DS3Config] Defines the DS3 (T3) interfaces. The parameter has the following
format:
[DS3CONFIG]
FORMAT DS3CONFIG_Index = DS3CONFIG_FramingMethod,
DS3CONFIG_ClockSource, DS3CONFIG_LineBuildOut,
DS3CONFIG_CircuitIdentifier, DS3CONFIG_TrapEnable,
DS3CONFIG_PmOnOff, DS3CONFIG_TappingEnable,
DS3CONFIG_AdminState;
[\DS3CONFIG]
For example:

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English