AudioCodes Mediant 3000 User Manual

Version 7.0 947 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
Inter Digit Timeout for Overlap
Dialing
[TimeBetweenDigits]
Defines the time (in seconds) that the device waits between digits
that are received from the PSTN or IP during overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
58.10.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Table 58-44: Voice Mail Parameters
Parameter Description
Voice Mail Interface
[VoiceMailInterface]
Enables the device's Voice Mail application and determines the
communication method between the device and PBX.
 [0] None (default)
 [1] DTMF
 [2] SMDI
 [3] QSIG
 [4] SETUP Only = Applicable only to ISDN.
 [5] MATRA/AASTRA QSIG
 [6] QSIG SIEMENS = QSIG MWI activate and deactivate messages
include Siemens Manufacturer Specific Information (MSI)
 [8] ETSI = Euro ISDN, according to ETS 300 745-1 V1.2.4, section
9.5.1.1. Enables MWI interworking from IP to Tel, typically used for
BRI phones.
 [9] NI2= ISDN PRI trunks set to NI-2. This is used for interworking
the SIP Message Waiting Indication (MWI) NOTIFY message to
ISDN PRI NI-2 Message Waiting Notification (MWN) that is sent in
the ISDN Facility IE message. This option is applicable when the
device is connected to a PBX through an ISDN PRI trunk configured
to NI-2.
Note: To disable voice mail per Trunk Group, you can use a Tel Profile
with the EnableVoiceMailDelay parameter set to disabled (0). This
eliminates the phenomenon of call delay on Trunks not implementing
voice mail when voice mail is enabled using this global parameter.
Enable VoiceMail URI
[EnableVMURI]
Enables the interworking of target and cause for redirection from Tel to
IP and vice versa, according to RFC 4468.
 [0] Disable (default)
 [1] Enable
Upon receipt of an ISDN Setup message with Redirect values, the
device maps the Redirect phone number to the SIP 'target' parameter
and the Redirect number reason to the SIP 'cause' parameter in the
Request-URI.
Redirecting Reason >> SIP Response Code
Unknown >> 404

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English