AudioCodes Mediant 3000 User Manual

User's Manual 974 Document #: LTRT-89730
Mediant 3000
Parameter Description
CASTableIndex.
[CASTablesNum] Defines how many CAS protocol configurations files are loaded.
The valid range is 1 to 8.
Note: For the parameter to take effect, a device reset is required.
CAS State Machines Parameters
Note: For configuring the CAS State Machine table using the Web interface, see ''Configuring CAS
State Machines'' on page 439.
Generate Digit On Time
[CASStateMachineGenerateDig
itOnTime]
Generates digit on-time (in msec).
The value must be a positive value. The default is -1.
Generate Inter Digit Time
[CASStateMachineGenerateInt
erDigitTime]
Generates digit off-time (in msec).
The value must be a positive value. The default is -1.
DTMF Max Detection Time
[CASStateMachineDTMFMaxO
nDetectionTime]
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default is -1.
DTMF Min Detection Time
[CASStateMachineDTMFMinOn
DetectionTime]
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may be
used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default is -1.
MAX Incoming Address Digits
[CASStateMachineMaxNumOfI
ncomingAddressDigits]
Defines the limitation for the maximum address digits that need to
be collected. After reaching this number of digits, the collection of
address digits is stopped.
The value must be an integer. The default is -1.
MAX Incoming ANI Digits
[CASStateMachineMaxNumOfI
ncomingANIDigits]
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of ANI
digits is stopped.
The value must be an integer. The default is -1.
Collect ANI
[CASStateMachineCollectANI]
In some cases, when the state machine handles the ANI collection
(not related to MFCR2), you can enable the state machine to
collect ANI or discard ANI.
 [0] No = Don't collect ANI.
 [1] Yes = Collect ANI.

[-1]
Default = Default value.
Digit Signaling System
[CASStateMachineDigitSignalin
gSystem]
Defines which Signaling System to use in both directions
(detection\generation).
 [0] DTMF = DTMF signaling.
 [1] MF = (Default) MF signaling.
 [-1] Default = Default value.
58.10.6.4 ISDN Parameters
The ISDN parameters are described in the table below.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English