User's Manual 672 Document #: LTRT-89730
Mediant 3000
5. Click the LOCK button; a confirmation message box appears requesting you to
confirm device lock.
6. Click OK to confirm device lock; if you set 'Graceful Option' to Yes, a lock icon is
delayed and a window appears displaying the number of remaining calls and time. If
you set 'Graceful Option' to No, the lock process begins immediately. The 'Gateway
Operational State' field displays "LOCKED".
 To unlock the device:
• Under the 'LOCK / UNLOCK' group, click the UNLOCK button. Unlock starts
immediately and the device accepts new incoming calls. The 'Gateway
Operational State' field displays "UNLOCKED".
Note: The Home page's General Information pane displays whether the device is
locked or unlocked (see ''Viewing the Home Page'' on page 79).
41.4 Saving Configuration
The Maintenance Actions page allows you to save (burn) the current parameter
configuration (including loaded Auxiliary files) to the device's non-volatile memory (i.e.,
flash). The parameter modifications that you make throughout the Web interface's pages
are temporarily saved (to the volatile memory - RAM) when you click the Submit or Add
buttons on these pages. Parameter settings that are saved only to the device's RAM revert
to their previous settings after a hardware/software reset (or power failure). Therefore, to
ensure that your configuration changes are retained, you must save them to the device's
flash memory using the burn option described below.
 To save the changes to the non-volatile flash memory:
1. Open the Maintenance Actions page (see ''Basic Maintenance'' on page 669).
2. Under the 'Save Configuration' group, click the BURN button; a confirmation message
appears when the configuration successfully saves.
Notes:
• Saving configuration to the non-volatile memory may disrupt current traffic on the
device. To avoid this, disable all new traffic before saving, by performing a
graceful lock (see ''Locking and Unlocking the Device'' on page 671).
• Throughout the Web interface, parameters displayed with the lightning symbol
are not applied on-the-fly and require that you reset the device for them to take
effect (see ''Resetting the Device'' on page 669).
• The Home page's General Information pane displays whether the device is
currently "burning" the configuration (see ''Viewing the Home Page'' on page 79).
To Next Page
Loading...
Need help?
General
