Version 7.0 881 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description

[1] Yes = Proxy Set ID 0 is used.
Notes:
 The parameter must be used only for backward compatibility. If not
required for backward compatibility, make sure that the parameter is
disabled, and use the Proxy Set table for configuring all your Proxy
Sets (except for Proxy Set ID 0).
 If you are not using a proxy server, you must configure routing rules
to route the call.
 The parameter is applicable only to the Gateway application.
Proxy Name
[ProxyName]
Defines the Home Proxy domain name. If specified, this name is used as
the Request-URI in REGISTER, INVITE and other SIP messages, and
as the host part of the To header in INVITE messages. If not specified,
the Proxy IP address is used instead.
The valid value is a string of up to 49 characters.
Note: The parameter functions together with the UseProxyIPasHost
parameter.
Use Proxy IP as Host
[UseProxyIPasHost]
Enables the use of the proxy server's IP address (in dotted-decimal
notation) as the host name in SIP From and To headers in REGISTER
requests.
 [0] Disable (default)
 [1] Enable
If the parameter is disabled and the device registers to an IP Group (i.e.,
proxy server), it uses the string configured by the ProxyName parameter
as the host name in the REGISTER's Request-URI and uses the string
configured by the IP Group table parameter, SIPGroupName as the host
name in the To and From headers. If the IP Group is configured with a
Proxy Set that has multiple IP addresses, all the REGISTER messages
sent to these proxies are sent with the same host name.
Note: If the parameter is disabled and the ProxyName parameter is not
configured, the proxy's IP address is used as the host name in the
REGISTER Request-URI.
Redundancy Mode
[ProxyRedundancyMode]
Determines whether the device switches back to the primary Proxy after
using a redundant Proxy.
 [0] Parking = (Default) The device continues working with a
redundant (now active) Proxy until the next failure, after which it
works with the next redundant Proxy.
 [1] Homing = The device always tries to work with the primary Proxy
server (i.e., switches back to the primary Proxy whenever it's
available).
Note: To use this Proxy Redundancy mechanism, you need to enable
the keep-alive with Proxy option, by setting the parameter
EnableProxyKeepAlive to 1 or 2.
Proxy IP List Refresh
Time
[ProxyIPListRefreshTime]
Defines the time interval (in seconds) between each Proxy IP list refresh.
The range is 5 to 2,000,000. The default interval is 60.
Enable Fallback to
Routing Table
Determines whether the device falls back to the Tel-to-IP Routing table
for call routing when Proxy servers are unavailable.
To Next Page
Loading...
Need help?
General
