GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-6 Section 3-3 - Receiving and Unpacking the Equipment
3-3-2 Unpacking the Voluson i / Voluson e Modo Cart
1.) Cut the straps securing the shipping carton to the wooden base.
2.) Carefully cut the adhesive tape used to close the shipping carton and open the carton.
3.) Remove the packing slip (shipping consignment note) detailing the contents of the shipping carton
and keep close to hand, ready to check whether delivery is complete (according to packing list).
4.) Remove the packing material in front of and surrounding the Modo Cart. Continue to remove
additional packaging material as applicable during the following procedure steps.
5.) Using two people, carefully roll the Modo Cart down the unloading ramp to remove it completely
from the shipping carton.
Make sure the Modo Cart is standing firmly on the floor before applying the locking brake.
6.) Before commencing the installation procedure, check visual damage!
!! CAUTION:
When using sharp tools to open packing materials, take care to avoid cutting or damaging any
of the contents.
Figure 3-5 Shipping carton - Voluson Modo Cart
!! CAUTION:
Have two people available to move the Modo Cart
Attempts to move the unit considerable distances or on an incline by one person could
result in injury or damage, or both.
Wooden Base
Securing straps
To Next Page
Loading...
Need help?
General
