SECTION 1: T200 OVERVIEW T200 User's Manual
PAGE 1-9
1.5.1 Units with A.C. Mains Input Interface (T200-310 to T200-710)
All current ratings are specified in ampere r.m.s.
T200-310 T200-410 T200-510 T200-610 T200-710
AC Mains Input Range
Minimum
Maximum
100Va.c. (120Va.c. -15%)
255Va.c. (230Va.c. +10%)
195Va.c. (230Va.c. -15%)
255Va.c. (230Va.c. +10%)
Frequency Range
50..60Hz
Continuous Input Power
Three-Phase
7.5kW 15kW
Single Phase 230Va.c.
2.5kW Not Available
Single Phase 120Va.c.
1.2kW Not Available
Max Rated Input Power (for
15 seconds)
Three-Phase 230Va.c.
15kW 30kW
Single Phase 230Va.c.
5.0kW Not Available
Single Phase 120Va.c.
2.4kW Not Available
Maximum Number of T200-
X00's (units without A.C.
Mains PSU) which can be
connected to a T200-X10
four
Note that application power requirements will also set a limit on the number of T200-
X00's (i.e. units without Mains PSU) which may be connected to a T200-X10 (unit
with Mains PSU). See Section 3.10 for guidelines on how to match application
power requirements for each T200-X10 unit.
D.C. Bus Rated Continuous
Output Power
(T200-310 to T200-710)
20Ad.c. at 325Vd.c. (6.5kW)
Internal Regeneration Power
Continuous Dissipation
40W No internal regen
Peak Dissipation
2.8kW capability
External Regeneration Power
Continuous / Peak
200W / 14kW
(1 * 50Ω)
600W / 14kW
(1 * 10Ω)
600W / 14KW (1 * 10Ω)
1250W / 18kW (1 * 8Ω)
2000W / 28kW (2 * 10Ω)
2500W / 36kW (2 *8Ω)
Soft-start Peak Inrush
Current/Phase
7Apeak
Power Supply Fault Detection
A.C. Mains not present
D.C. Bus Overvoltage
Internal Regeneration Fuse Blown
Power Supply Temperature Fault
Voltage Discharge after A.C.
Mains Removal
Fast Bus Discharge function
Bleed Resistors across high voltage section
Power Sequencing Control
Power Ready output provided to control power application
Table 1.3: T200-X10 Power Ratings
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
