SECTION 2: SAFETY INSTRUCTIONS T200 User's Manual
PAGE 2-3
2.1 General
This user’s manual is intended to provide sufficient information on how to install, wire and tune a Moog brushless
electric motor system which includes all of the equipment outlined in Section 3.1. Section 2.2 covers Safety and System
Safeguards. Section 2.3 covers Electromagnetic Compatibility (EMC). This user’s guide must be read and understood
before applying power and operating the equipment described.
This equipment must be installed and serviced only by duly qualified service personnel. All information in this manual
is directed towards such persons only. Individuals responsible for the installation of the equipment described in this
user’s guide must ensure ;
1) only technically qualified individuals are employed to work on the installation,
2) these qualified individuals must have the accompanying documentation available at all times when working on the
installation and are obliged to use this documentation in a consistent manner, and
3) work on, or close to, the installation is prohibited for non-technically qualified individuals
Throughout this user’s guide may be found NOTES, CAUTIONS, and WARNINGS and CE-Compliance-Required.
They are defined as follows:
The T200 controller contains potentially lethal voltages. Extreme caution shall be observed whenever the equipment is
in operation. Incorrect installation of the motor or the controller may cause damage to the equipment, serious personal
injury or death. Consequently, the instructions in this user’s manual, as well as national and local rules and safety
regulations, must be complied with.
NOTES are general in nature and are intended to emphasise
information.
are to alert personnel to actions that could cause
equipment damage, resulting in the equipment becoming
unsafe.
WARNINGS serve to make personnel aware of potentially
hazardous actions that may result in personal injury or death.
Required for
CE-Compliance
CE-Compliance indicates where a particular application-
related safety or EMC requirement is driven by the need for
CE-Compliance of the T200 when installed in the system.
Customers who do not need CE-Compliance on their machinery
may choose not to implement these features.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
