T200 User's Manual SECTION 2: SAFETY INSTRUCTIONS
PAGE 2-8
2.3.2 Equipment Safety
All persons must observe sound safety practices during the operation and testing of all electrically powered equipment.
Prior to first use, power should not be applied to the T200 Servo-drive until all instructions in the Wiring and Installation
section of this User’s manual have been carried out.
- DO NOT remove or replace any assemblies, subassemblies or components
with primary power present.
WARNING - Lethal voltages remain present within this equipment when the mains power
is removed. It is recommended to refrain from commencing any servicing, maintenance,
repair or upgrading of this equipment until at least five minutes after power shutdown. It is
further recommended to measure the voltage level at all high voltage terminals before
commencing any such activities, to ensure that no lethal voltages are present.
WARNING - Repair or internal adjustments to the T200 Series Controllers must not be
attempted. All faulty items must be returned to Moog Service Centres for maintenance and
repair.
WARNING - Entering the workcell when HIGH POWER or PROGRAM RUNNING
indicators are ON may result in severe injury.
WARNING – The removable plug-in connectors of the T200 Servo-Drives are for ease of
wiring installation. These removable plug-in connectors are not suitable for connection or
disconnection under power. All connections must be made with power removed.
WARNING – You must disconnect the T200 Servo-drive from all voltage supplies
(230 Va.c., 120 Va.c., 24 Vd.c.) before servicing.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
