SECTION 2: SAFETY INSTRUCTIONS T200 User's Manual
PAGE 2-15
2.4 Electromagnetic Compatibility (EMC)
The T200 Servo-drive are system components which must be installed in a correct manner to ensure that all
electromagnetic compatibility (EMC) requirements are met. The requirements of European Union (EU) EMC Directive:
89/336/EEC (as amended by EU Directives 92/31/EEC and 93/68/EEC ) must be met by all equipment, systems and
installations into which the T200 Servo-drive are installed.
For further information on the requirements of EU EMC Directive the user is recommended to refer to the latest
publications of the EU Commission and to local regulations.
The T200 Servo-drive have been tested for compliance with the requirements of the EU EMC Directive in so far as they
can be regarded as single functional units. The T200 Power Supply and Controller have been tested in typical
configurations and it has been found that these configurations meet the essential requirements of the EU EMC Directive.
Details of these configurations are given in Appendix A.
The EMC standards applied were as follows:
• EMC Emission Standard EN 55011:1991, Limits and methods of measurement of radio disturbance characteristics
of industrial, scientific and medical (ISM) radio-frequency equipment. (Group 1, Class A).
• EMC Immunity standard EN 50082-2:1995, Electromagnetic compatibility Generic Immunity Standard Part 2:
Industrial Environment.
Both these standards are published by CENELEC, the European Committee for Electrotechnical Standardisation,
Brussels.
2.4.1 Specific Electromagnetic Compatibility (EMC) Requirements:
The EMC measures outlined below are required to be installed by the user into all equipment, systems and installations
into which the T200 are installed. Further details are given in the referenced sections of this User’s Guide.
The T200 Servo-drive must be installed by mounting on a panel in a manner that ensures that EMC earthing
requirements are met. (Refer Section 3 of this User’s Guide).
An optional EMC kit is available to facilitate earthing of cable shields prior to entering the T200. Cable shields must be
bonded to either the panel earthing bar or the optional EMC kit.
For safety reasons the T200 Servo-drive, and the panel on which they are mounted must be installed in enclosures or
cabinets which provide a degree of ingress protection against liquids and objects of at least IP54. These enclosures or
cabinets must be accessible to technically qualified service or maintenance persons only.
User's whose machine installations are intended for CE-
Compliance should read Section 2.4. Otherwise reading
of Section 2.4 is not required.
Required for
CE-Compliance
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
