SIP User's Manual 148 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
¾ To configure the RADIUS parameters, take these 4 steps:
1. Open the ‘RADIUS Parameters' screen (Protocol Management menu > Advanced
Applications submenu > RADIUS Parameters).
Figure 5-27: RADIUS Parameters Screen
2. Configure the RADIUS accounting parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to 'Saving Configuration' on page 256.
Table 5-25: RADIUS Parameters
Parameter Description
Enable RADIUS
EnableRADIUS
Enables or disables the RADIUS application.
Valid options include:
 [0] Disables = disables RADIUS application (default)
 [1] Enable = enables RADIUS application
RADIUS Accounting Server
IP Address
[RADIUSAccServerIP]
IP address of the RADIUS accounting server.
RADIUS Accounting Port
[RADIUSAccPort]
Port of the RADIUS accounting server.
The default value is 1646.
RADIUS Accounting Type
[RADIUSAccountingType]
Determines when the RADIUS accounting messages are sent to the
RADIUS accounting server.
Valid options include:
 [0] At Call Release = Sent at the release of the call only (default).
 [1] At Connect and Release = Sent at the connect and release of the
call.
 [2] At Setup and Release = Sent at the setup and release of the call.
AAA Indications
[AAAIndications]
Determines which Authentication, Authorization and Accounting (AAA)
indications to use.
Valid options include:
 [0] None = No indications (default).
 [3] Accounting Only = Only accounting indications are used.
To Next Page
Loading...
Need help?
General