SIP User's Manual 260 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
5.13.6.2 Restoring Default Settings
You can use the gateway's hardware Reset button to restore all the gateway's
configuration settings to default (e.g., IP address and login username and password).
These default settings include factory as well as user-defined (refer to 'Defining Default
Values' on page 259) defaults, where user-defined defaults override corresponding factory
defaults.
¾ To restore the gateway to default settings, take these 4 steps:
1. Disconnect the gateway from the power and network cables.
2. Reconnect the power cable; the gateway powers up. After approximately 45 seconds,
the ACT LED flashes for about 4 seconds.
3. While the ACT LED is flashing, press the Reset button (located on the TP-1610's front
panel); the gateway resets a second time and is restored with default parameters.
4. Reconnect the network cable.
îš„
5.14 Using the Home Page
The Home icon, located above the main menu bar, opens the Home page. This page
provides you with a graphical display of the gateway's front-panel, allowing you to view
various gateway statuses.
To Next Page
Loading...
Need help?
General