Version 5.2 293 September 2007
SIP User's Manual 6. ini File Configuration
6.5.6 SNMP Parameters
Table 6-6: SNMP Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
DisableSNMP
For a description of this parameter, refer to 'Configuring the
Management Settings' on page 218.
SNMPPort
The device's local UDP port used for SNMP Get/Set commands.
The range is 100 to 3999. The default port is 161.
SNMPTrustedMGR_x
Up to five IP addresses of remote trusted SNMP managers from
which the SNMP agent accepts and processes get and set
requests.
Notes:
 If no values are assigned to these parameters any manager can
access the device.
 Trusted managers can work with all community strings.
KeepAliveTrapPort
The port to which the keep-alive traps are sent.
The valid range is 0 - 65534. The default is port 162.
SendKeepAliveTrap
When enabled, this parameter invokes the keep-alive trap and
sends it every 9/10 of the time defined in the parameter defining
NAT Binding Default Timeout.
 [0] = Disable
 [1] = Enable
SNMPSysOid
Defines the base product system OID.
Default is eSNMP_AC_PRODUCT_BASE_OID_D.
SNMPTrapEnterpriseOid
Defines a Trap Enterprise OID.
Default is eSNMP_AC_ENTERPRISE_OID.
The inner shift of the trap in the AcTrap subtree is added to the
end of the OID in this parameter.
acUserInputAlarmDescription
Defines the description of the input alarm.
acUserInputAlarmSeverity
Defines the severity of the input alarm.
AlarmHistoryTableMaxSize
Determines the maximum number of rows in the Alarm History
table.
The parameter can be controlled by the Config Global Entry Limit
MIB (located in the Notification Log MIB).
The valid range is 50 to 1000. The default value is 500.
SNMP Trap Parameters
SNMPManagerTableIP_x
For a description of this parameter, refer to 'Configuring the SNMP
Managers Table' on page 221.
SNMPManagerTrapPort_x
For a description of this parameter, refer to 'Configuring the SNMP
Managers Table' on page 221.
To Next Page
Loading...
Need help?
General