Version 5.2 29 September 2007
SIP User's Manual 3. Installation
3 Installation
This section provides detailed information on the installation procedures for the following
products:
îš„ Mediant 2000 (refer to 'Installing the Mediant 2000' on page 29)
îš„ TP-1610 (refer to 'Installing the TP-1610' on page 40)
îš„ TP-260 (refer to 'Installing the TP-260' on page 43)
For information on how to start using the gateway, refer to 'Getting Started' on page 47.
Caution Electrical Shock
The equipment must only be installed or serviced by qualified service
personnel.
3.1 Installing the Mediant 2000
To install the Mediant 2000, perform the following installation steps in chronological order:
îš„ Unpack the Mediant 2000 (refer to 'Unpacking' on page 29)
îš„ Check the package contents (refer to 'Package Contents' on page 30)
îš„ Mount the Mediant 2000 (refer to 'Mounting the Mediant 2000' on page 30)
îš„ Cable the Mediant 2000 (refer to 'Cabling the Mediant 2000' on page 33)
After powering-up the Mediant 2000, the Ready and LAN LEDs on the front panel turn to
green (after a self-testing period of about 3 minutes). Any malfunction changes the Ready
LED to red (for details on the Mediant 2000 LEDs, refer to 'TP-1610 Front Panel LEDs' on
page 22).
When you have completed the above installation steps, you are ready to start configuring
the gateway (refer to 'Getting Started' on page 47).
3.1.1 Unpacking
Follow the procedure below for unpacking the received carton in which the Mediant 2000 is
shipped.
¾ To unpack the Mediant 2000, take these 6 steps:
1. Open the carton and remove packing materials.
2. Remove the Mediant 2000 from the carton.
3. Check that there is no equipment damage.
4. Check, retain and process any documents.
5. Notify AudioCodes or your local supplier of any damage or discrepancies.
6. Retain any diskettes or CDs.
To Next Page
Loading...
Need help?
General