Version 5.2 287 September 2007
SIP User's Manual 6. ini File Configuration
6.5.3 Web and Telnet Parameters
Table 6-3: Web and Telnet Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
WebAccessList_x
Defines up to ten IP addresses that are permitted to access the
gateway's Embedded Web Server and Telnet interfaces. Access from an
undefined IP address is denied. This security feature is inactive (the
gateway can be accessed from any IP address) when the table is empty.
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
The default value is 0.0.0.0 (the gateway can be accessed from any IP
address).
For defining the Web and Telnet Access list using the Embedded Web
Server, refer to 'Configuring the Web and Telnet Access List' on page
199.
WebRADIUSLogin
For a description of this parameter, refer to 'Configuring the General
Security Settings' on page 206.
DisableWebTask
 [0] = Enable Web management (default).
 [1] = Disable Web management.
ResetWebPassword
Resets the username and password of the primary and secondary
accounts to their defaults.
 [0] = Password and username retain their values (default).
 [1] = Password and username are reset (for the default username
and password, refer to 'User Accounts' on page 58).
Note: The username and password cannot be reset from the Embedded
Web Server (i.e., via AdminPage or by loading an ini file).
To Next Page
Loading...
Need help?
General