SIP User's Manual 158 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
Table 5-28: Network Settings, Application Settings Parameters
Parameter Description
NTP Settings
For detailed information on Network Time Protocol (NTP), refer to 'Simple Network Time Protocol
Support' on page 372.
NTP Server IP Address
[NTPServerIP]
IP address (in dotted format notation) of the NTP server.
The default IP address is 0.0.0.0 (the internal NTP client is disabled).
NTP UTC Offset
[NTPServerUTCOffset]
Defines the UTC (Universal Time Coordinate) offset (in seconds)
from the NTP server.
The default offset is 0. The offset range is -43200 to 43200 seconds.
NTP Update Interval
[NTPUpdateInterval]
Defines the time interval (in seconds) the NTP client requests for a
time update.
The default interval is 86400 seconds (24 hours). The range is 0 to
214783647 seconds.
Note: It isn't recommended to be set beyond one month (2592000
seconds).
Telnet Settings
Embedded Telnet Server
[TelnetServerEnable]
Enables or disables the embedded Telnet server. Telnet is disabled
by default for security reasons.
 [0] Disable (default).
 [1] Enable (Unsecured).
 [2] Enable Secured (SSL).
Telnet Server TCP Port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Telnet Server Idle Timeout
[TelnetServerIdleDisconnect]
Sets the timeout for disconnection of an idle Telnet session (in
minutes). When set to zero, idle sessions are not disconnected.
The valid range is any value. The default value is 0.
SSH Server Enable
[SSHServerEnable]
Enables or disables the embedded Secure SHell (SSH) server.
 [0] Disable = Disable SSH server (default)
 [1] Enable = Enable
SSH Server Port
[SSHServerPort]
Defines the port number for the embedded SSH server.
Range is any valid port number. Default is port 23.
To Next Page
Loading...
Need help?
General