SIP User's Manual 40 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
3.2 Installing the TP-1610
Electrical Earthing
Prior to installation of any blade in a chassis, always correctly connect the
chassis to a safety ground according to the laws and regulations of the country
in which the installation is performed.
Electrical Component Sensitivity
Electronic components on printed circuit boards (PCB) are extremely sensitive
to static electricity. Normal amounts of static electricity generated by clothing
can damage electronic equipment. To reduce the risk of damage due to
electrostatic discharge when installing or servicing electronic equipment, it is
recommended that anti-static earthing straps and mats be used.
To install the TP-1610, take these four chronological steps:
îš„ Unpack the TP-1610 (refer to 'Unpacking' on page 40)
îš„ Check the package contents (refer to 'Package Contents' on page 41)
îš„ Install the TP-1610 in a compactPCIâ„¢ chassis (refer to 'Installing the TP-1610' on
page 41)
îš„ Cable the TP-1610 (refer to 'Cabling the TP-1610' on page 42)
When you have completed the above installation steps, you are then ready to start
configuring the gateway (refer to 'Web-based Management' on page 57).
3.2.1 Unpacking
Follow the procedure below for unpacking the received carton in which the TP-1610 is
shipped.
¾ To unpack the TP-1610, take these 6 steps:
1. Open the carton and remove packing materials.
2. Remove the TP-1610 blade from the carton.
3. Check that there is no equipment damage.
4. Check, retain, and process any documents.
5. Notify AudioCodes or your local supplier of any damage or discrepancies.
6. Retain any diskettes or CDs.
To Next Page
Loading...
Need help?
General