SIP User's Manual 254 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
5.13 Maintenance
The Maintenance menu is used for the following operations:
îš„ Locking and unlocking the gateway (refer to 'Locking and Unlocking the Gateway' on
page 254)
îš„ Saving the gateway's configuration (refer to 'Saving Configuration' on page 256)
îš„ Resetting the gateway (refer to 'Resetting the Gateway' on page 257)
5.13.1 Regional Settings
The 'Regional Settings' screen allows you to define and view the gateway's internal date
and time.
¾ To configure the gateway's date and time, take these 3 steps:
1. Open the 'Regional Settings' screen (Advanced Configuration menu > Regional
Settings).
Figure 5-63: Regional Settings Screen
2. Enter the time and date where the gateway is installed.
3. Click the Set Date & Time button; the date and time are automatically updated.
Notes:
• After performing a hardware reset, the date and time are returned to their
defaults and should therefore be updated.
• For configuring the gateway to obtain the time from an SNTP server,
refer to 'Simple Network Time Protocol Support' on page 372.
5.13.2 Locking and Unlocking the Gateway
The Lock and Unlock options allow you to lock the gateway so that it doesn't accept any
new incoming calls. This is beneficial when, for example, you are uploading new software
files to the gateway and you don't want any traffic to interfere with the process.
To Next Page
Loading...
Need help?
General