Staplers
● When you are using the Staple mode, do not remove the stack of paper from the output tray during the job.
Remove the stack of paper when the job has been completed.
● If the <Load staples into the stapler unit.> message appears, almost all of the staples have been used. To
proceed, replace the staple cartridge.
● If a tray reaches the lowest position limit, printing stops temporarily. Remove all of the output paper from
the tray to resume printing.
Saddle stitch
● The accuracy of folds may vary depending on the paper type and the number of sheets.
Appendix
1109
To Next Page
Loading...
Need help?
General
