Placing Originals in the Feeder
1
Spread the slide guides apart.
● Move the slide guides outward until they are slightly farther apart than the actual width of the original.
● When placing large-sized originals, pull out the original supply tray extension and original output tray
extension to prevent them from dropping over the edge of the feeder.
2
Fan the original stack and align the edges.
● Fan the original stack in small batches, and align the edges by lightly tapping the stack on a at surface a few
times.
3
Place the originals face up in the feeder.
Basic Operations
108
To Next Page
Loading...
Need help?
General
