Suzuki Intruder VZ800 User Manual

3-56 ENGINE
• When installing the starter clutch guide 2, make sure that the
flange B side faces out.
• Apply THREAD LOCK SUPER “1303” to the securing bolts
and tighten them to the specified torque while holding the
rotor with off-set wrench.
99000-32030: THREAD LOCK SUPER “1303”
 Starter clutch securing bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
OIL PUMP
• Rotate the oil pump by hand and check that it moves
smoothly.
• If it does not move smoothly, replace the oil pump assembly.

Do not attempt to disassemble the oil pump assembly.
The oil pump is available only as an assembly.
SAMPLE

Suzuki Intruder VZ800 Specifications

General

Engine Type	4-stroke, liquid-cooled, DOHC, 45-degree V-twin
Displacement	805 cc
Bore x Stroke	83.0 mm x 74.4 mm
Compression Ratio	9.4:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Rear Brake	Drum brake
Seat Height	700 mm (27.6 in)
Front Brake	Disc brake
Rear Tire	170/80-15M/C 77H, tube type
Fuel Tank Capacity	15.5 L (4.1 US gallons)