Electrical Safety
GENERAL GUIDELINES
WWaarrnniinngg::
• Do not push objects into slots or openings on the printer. Touching a voltage point
or shorting out a part could result in fire or electric shock.
• Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are instructed to do so. Turn off the printer when
performing these installations. Disconnect the power cord when removing covers
and guards for installing optional equipment. Except for user-installable options,
there are no parts that you can maintain or service behind these covers.
EMERGENCY POWER OFF
The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the printer.
• The printer is exposed to water.
• The printer emits smoke, or the surface is unusually hot.
• The printer emits unusual noise or odors.
• The printer causes a circuit breaker, fuse, or other safety device to activate.
If any of these conditions occur, do the following:
1. Turn off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
POWER CORD AND ELECTRICAL SUPPLY
WWaarrnniinngg::
• Use the power cord supplied with your printer.
• Do not remove or modify the power cord.
• Ensure that the electrical outlet is near the printer and is easily accessible.
• Plug the power cord directly into a properly grounded electrical outlet. Ensure that
each end of the cord is connected securely. If you do not know if an outlet is
grounded, ask an electrician to check the outlet.
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide 21
Safety
To Next Page
Loading...
Need help?
General