1. Load the paper into tray T1. If the paper is pre-printed, load the paper with the printed side facing up. Align all
edges of the paper.
Note: To avoid possible paper jams or printer malfunctions, do not load paper above the maximum fill line.
2. Grasp the center of the paper guides and gently slide the guides to the required paper size so that the guides
touch the edges of the paper.
Note:
• If the distance between the guides is too long or short for the paper, paper jams can occur.
• If set by the system administrator, the Tray Properties screen appears on the printer control panel.
3. From the Tray Properties screen, enter or verify the correct paper information.
4. To save the paper information and close the Tray Properties screen, touch OOKK.
PRINTING ON SPECIAL MEDIA
HHoollee--PPuunncchheedd PPaappeerr
Load hole-punched paper into tray T1, LEF (long-egde feed), and with the holes on the right side, as shown.
348
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide
Inserter Module
To Next Page
Loading...
Need help?
General