GE MEDICAL SYSTEMS PROPRIETARY TO GE
D
IRECTION 2294854-100, REVISION 3 LOGIQ™ 9 PROPRIETARY MANUAL
5-24 Section 5-4 - Back End Processor (BEP)
5-4-1 Enclosure
The EMC enclosure shall house an ATX Power Supply with UPS battery backup, an ATX style
motherboard with minimum of 512 MB of ram and two 733MHz processors
5-4-2 PCI Cards
5 PCI slots on the mother board shall contain the following:
1.) PCI Video Card - Digital Video to the Touch Panel
2.) Sound Card - Sound Blaster Live for audio to speakers
3.) Blank or PCI Bird 3D Card - Option
4.) PC2IP Card - GE designed. PCI Bus interface to the Front End Processor
5.) Network Interface Card - 3Com Ethernet Card
5-4-3 AGP Video Card - SVGA Video to the PCVIC Card
• Analog output shall comply with the SVGA specification.
• Resolution shall be 800x600.
• Support for 32 bit True Color
• Minimum of 8 Mbytes of high speed Video RAM, expandable to at least 16 Mbytes.
• 128-bit internal memory interface.
• Hardware supported asynchronous bit block transfer (80 Mpixels/sec).
• Full Direct 3D and Open-GI support (desirable).
5-4-4 PCIO Board:
This GE designed board does not plug into any slot but is mounted to the inside of the PC chassis.
- Power and Internal PCI control signals
5-4-5 PCVIC Card
- Input from AGP Video card (BEP1.0) or Motherboard AGP Video (BEP 2.0)
This GE designed board does not plug into any slot but is mounted to the inside of the PC chassis.
- SVGA output to the image monitor
- RGB output to color printer
5-4-6 DGVIC, DGIO and ADD Cards BEP 2.1 (BT’02, November 2002)
The ADD Card is a PCI card that mimics the AGP video and provides a digital video output to the DGVIC
board.
The DGVIC converts the digital video to RGBS, SVGA (to Monitor and External I/O), S-video and
Composite video outputs.
The DGIO provides signals and power to I/O boards. Signals like PS_ON, I
2
C, RS232, PC Power and
PC On/Off.
To Next Page
Loading...
Need help?
General
