Receiver Mode
R&S
®
ESR
162User Manual 1175.7068.02 ─ 12
Skip Frequency
Skips the peak list entry the final measurement is due to measure next and proceeds
with the next peak.
Available for interactive final measurements.
Remote command:
-
Get Maxhold
Uses the highest level that was measured during the scan for the final results instead
of the signal level measured during the final measurement.
Remote command:
-
Measure
Initiates a final measurement on the current peak.
Available for interactive final measurements.
Remote command:
-
Stop Final Measurement
Aborts the final measurement.
Data that has already been collected is lost.
Remote command:
ABORt on page 640
5.1.7.6 Measurement Settings
The "Meas" menu contains the basic measurement settings and the selection of result
displays (Chapter 5.1.7.2, "Selecting the Result Display", on page 156).
► Press the [MEAS] key.
The R&S ESR opens the "Measurement" menu.
Receiver Frequency....................................................................................................162
Bargraph Detector.......................................................................................................163
└ Couple to Scan Trace................................................................................... 163
Measurement Time..................................................................................................... 163
Demod.........................................................................................................................163
└ Demod (On Off)............................................................................................ 163
└ AM / FM........................................................................................................ 163
└ Squelch.........................................................................................................164
Add To Peak List......................................................................................................... 164
Test Automation.......................................................................................................... 164
Receiver Frequency
Defines the receiver frequency.
Measurements and Result Displays
To Next Page
Loading...
Need help?
General
