R&S ESR Series User Manual

Spectrum Measurements
R&S
®
ESR
406User Manual 1175.7068.02 ─ 12
Remote command:
CALCulate<n>:SGRam:HDEPth on page 651
Color Mapping ← Spectrogram
Displays the "Color Mapping" dialog box to configure the display of the spectrogram
(assignment of colors to power levels).
For more information see Chapter 5.1.6.2, "Color Map", on page 152.
Remote command:
CALCulate<n>:SGRam:COLor on page 856
DISPlay:WINDow:SGRam:COLor:LOWer on page 650
DISPlay:WINDow:SGRam:COLor:UPPer on page 650
Time Stamp (On Off) ← Spectrogram
Activates and deactivates the time stamp. The time stamp shows the system time
while the measurement is running. In single sweep mode or if the sweep is stopped,
the time stamp shows the time and date of the end of the sweep.
When active, the time stamp replaces the display of the frame number.
Remote command:
CALCulate<n>:SGRam:TSTamp[:STATe] on page 858
Clear Spectrogram ← Spectrogram
Resets the Spectrogram result display and clears the history buffer.
Remote command:
CALCulate<n>:SGRam:CLEar[:IMMediate] on page 649
6.3.3 Markers
6.3.3.1 Controlling Markers
The markers are used for marking points on traces, reading out measurement results
and for selecting a display section quickly. The R&S ESR provides 16 markers per
trace.
To open the Marker menu
●
Press the MKR key.
The "Marker" menu is displayed. If no marker is active, marker 1 is activated and a
peak search on the trace is carried out. Otherwise, the edit dialog box for the last
activated marker is opened and the current frequency/time value is displayed.
Further information
●
"Displayed Marker Information" on page 410
●
Chapter 5.4.2.2, "Positioning Markers", on page 204.
Analysis

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English