R&S ESR Series User Manual

Remote Control
R&S
®
ESR
976User Manual 1175.7068.02 ─ 12
Manual operation: See "Selecting Datasets for the Report" on page 551
HCOPy:TREPort:TEST:SELect:INVert
This command inverts the current selection of datasets to be included in the test report.
Datasets that have been included in the report before will no longer be part of the
report. Instead, the previously deselected datasets will be included.
Example:
HCOP:TREP:TEST:SEL:INV
Inverts the selection of dataset to be included in a test report.
Usage: Event
Manual operation: See "Selecting Datasets for the Report" on page 551
HCOPy:TREPort:TEST:SELect:NONE
This command excludes all datasets from the test report.
Example:
HCOP:TREP:TEST:SEL:NONE
Removes all dataset from the test report.
Usage: Event
Manual operation: See "Selecting Datasets for the Report" on page 551
11.13.3 Deprecated Commands (Test Report)
Following is a list of deprecated remote commands. The remote commands are still
supported to maintain compatibility to previous Rohde & Schwarz receivers (like the
R&S ESU), but it is strongly recommended to use the command system in the way it is
meant to be used in the R&S ESR.
Legacy command Replaced by Comment
HCOPy:TREPort:ITEM:HEADer:
STATe
HCOPy:TREPort:ITEM:SELect
Items now selected by the command parameter.
HCOPy:TREPort:ITEM:
DIAGram:STATe
HCOPy:TREPort:ITEM:SELect
Items now selected by the command parameter.
HCOPy:TREPort:ITEM:
FRESults:STATe
HCOPy:TREPort:ITEM:SELect
Items now selected by the command parameter.
HCOPy:TREPort:ITEM:
PAGecount:STATe
HCOPy:TREPort:ITEM:SELect
Items now selected by the command parameter.
HCOPy:TREPort:ITEM:
SCANtable:STATe
HCOPy:TREPort:ITEM:SELect
Items now selected by the command parameter.
HCOPy:TREPort:ITEM:
SRESults:STATe
HCOPy:TREPort:ITEM:SELect
Items now selected by the command parameter.
Working with Test Reports

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English