R&S ESR Series User Manual

Spectrum Measurements
R&S
®
ESR
430User Manual 1175.7068.02 ─ 12
To open the Lines menu
●
Press the [LINES] key.
The "Lines" menu and the "Select Limit Line" dialog box are displayed. For details on
the "Select Limit Line" dialog box refer to Chapter 5.4.3.5, "Selecting a Limit Line",
on page 215.
Menu and softkey description
●
Chapter 5.4.3.1, "Softkeys of the Lines Menu", on page 209
Further information
●
Chapter 5.4.3.2, "Display Lines", on page 213
●
Chapter 5.4.3.3, "Limit Lines (Frequency/Time Lines)", on page 214
Tasks
●
Chapter 5.4.3.4, "Working with Lines", on page 215
●
Chapter 5.4.3.5, "Selecting a Limit Line", on page 215
●
Chapter 5.4.3.6, "Creating a New Limit Line", on page 216
●
Chapter 5.4.3.7, "Editing an Existing Limit Line", on page 219
●
Chapter 5.4.3.8, "Creating a New Limit Line Based upon an Existing Limit Line",
on page 219
●
Chapter 5.4.3.9, "Activating/Deactivating a Limit Line", on page 220
6.4 Advanced Measurement Examples
This chapter explains how to operate the R&S ESR in spectrum mode using typical
measurements as examples. Additional background information on the settings is
given. For more detailed information on all available softkeys and the corresponding
instrument functions, see Chapter 6, "Spectrum Measurements", on page 221.
● Test Setup............................................................................................................. 430
● Measurement of Harmonics..................................................................................431
● Measuring the Spectra of Complex Signals..........................................................433
● Measuring Signals in the Vicinity of Noise............................................................ 436
● Noise Measurements............................................................................................ 441
● Measurements on Modulated Signals...................................................................448
6.4.1 Test Setup
All of the following examples are based on the standard settings of the R&S ESR.
These are set with the PRESET key. A complete listing of the standard settings can be
found in chapter "Instrument Functions", section "Initializing the Configuration – PRE-
SET Key".
Advanced Measurement Examples

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English