R&S ESR Series User Manual

Quick Start
R&S
®
ESR
91User Manual 1175.7068.02 ─ 12
3.4.4.11 Changing the Display Update Rate
When performance is poor due to slow data transfer (for example during remote con-
trol), it may be helpful to decrease the frequency with which the screen display is upda-
ted.
To descrease the display update rate
1. Press the [DISPLAY] key.
The "Display Settings" dialog box is opened.
2. Under "Display Update Rate", select "Slow".
The display is updated less frequently, and performance for measurements should
improve. When data transfer is no longer a problem, you can set the update rate
back to "Fast" in the same way.
3.5 Basic Measurement Examples
The following measurement examples are intended as an introduction to operating the
R&S ESR. The User Manual contains additional and more advanced examples. Refer
to chapter "Advanced Measurement Examples" to find the following topics:
●
High-Sensitivity Harmonics Measurements
●
Separating Signals by Selecting an Appropriate Resolution Bandwidth
●
Intermodulation Measurements
●
Measuring Signals in the Vicinity of Noise
●
Measuring Noise Power Density
●
Measurement of Noise Power within a Transmission Channel
●
Measuring Phase Noise
●
Measuring Channel Power and Adjacent Channel Power
For a more detailed description of the basic operating steps, e.g. selecting menus and
setting parameters, refer to Chapter 3.4, "Basic Operations", on page 63.
3.5.1 Measuring a Sinusoidal Signal
One of the most common measurement tasks that can be handled by using a signal
analyzer is determining the level and frequency of a signal. When measuring an
unknown signal, you can usually start with the presettings.
Basic Measurement Examples

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English