1-6
GENERAL
INFORMATION
A CAUTION
The
percentage of antifreeze in the coolant should be between 50 to 60%. If the percentage of
antifreeze is above or below this range the coolant's frost protection and rust-inhibiting
capa-
bilities
will
be reduced. Always keep the antifreeze content above 50% even if the atmospheric
temperature does not go below the freezing point.
BREAK-IN
PROCEDURES
During manufacturing only the best possible materials are used and all machined parts are finished to
a
very high standard.
It is
still
necessary
to
allow the moving parts
to
"BREAK-IN"
before subjecting
the
engine to maximum stresses. The future performance and
reliability
of the engine depends on the care and
restraint
exercised during its early
life.
Refer to the following break-in engine speed recommendations.
•
Keep to these brake-in engine speed
limits.
Break-in
engine
speeds
Initial
500 km (300 miles):
Less
than
1
2
throttle
•
Upon
reaching
an
odometer reading
of
500 km (300 miles) you can subject the vehicle to
full
throttle
operation,
for short periods of
time.
To Next Page
Loading...
Need help?
General
