Xerox Phaser 7100 Service Manual

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-134
Remote Directory Lock Error
Creation of Lock directory has failed.
Applicable Fault Code
• 016-736: Repository Lock Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Remote Lock Directory Remove Error
Deletion of Lock directory has failed. The power was turned OFF because the CDI Cable got
disconnected during FTP transfer or the DFE Reset SW was pressed.
Applicable Fault Code
• 016-737: Lock Directory Deletion Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. When a lock directory (*.LCK) remained in the transfer destination, delete it manually and retry the
job.
2. Make correct settings for the permissions to the transfer destination directories.
3. Secure a disk capacity if the HDD for the transfer destination directory is full.
Troubleshooting Procedure
Step Actions and Questions
1. When a lock directory (*.LCK) remained in the transfer destination, manually delete it and retry the
job.

Xerox Phaser 7100 Specifications

General

Brand	Xerox
Model	Phaser 7100
Category	Printer
Language	English