Xerox Phaser 7100 Service Manual

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-365
116-738 Size/ Orientation Mismatch
Form Overlay is impossible because the size/ orientation of the form’s drawing is different from that of
the paper.
Applicable Fault Code
• 116-738: <Form Overlay Error> Form Overlay is impossible because the size/ orientation of the
form's drawing is different from that of the paper.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
116-739 Out of Disk Area-Form/ Logo REGI ERR
The form/ logo data cannot be registered due to insufficient RAM or Hard Disk space.
Applicable Fault Code
• 116-739: <Insufficient form/logo capacity> The form/ logo data cannot be registered due to
insufficient RAM or Hard Disk space.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Select paper that has the same size and orientation as the registered form.
Troubleshooting Procedure
Step Actions and Questions
1. After checking the registered forms/logos using the Operation Panel utility, delete the unnecessary
forms/logos.
Or, increase the allocated capacity of the RAM disk.

Xerox Phaser 7100 Specifications

General

Brand	Xerox
Model	Phaser 7100
Category	Printer
Language	English