Xerox Phaser 7100 Service Manual

Service Parts Disassembly
Phaser 7100 Service Manual Xerox Internal Use Only4-80
REP 4.2 DRW Fuser Harness Assembly
PL 4.1.7
WARNING: The Fuser may be hot. Turn the printer power Off and allow at least 30 minutes for
the Fuser to cool before removing the Fuser.
1. Remove Tray 1.
2. Remove the Fuser Unit (REP 10.1 Fuser Unit on page 4-183).
3. Remove the I/P PWB Cover Assembly (REP 1.5 Image Processor (I/P) PWB Cover Assembly on
page 4-19).
4. Remove the Rear Cover (REP 1.6 Rear Cover on page 4-20).
5. Remove the Left Side Cover (REP 1.10 Left Side Cover on page 4-25).
6. Remove the Left Feeder Cover (REP 2.10 Left Feeder Cover on page 4-49).
7. Remove the Control Panel Assembly (REP 1.12 Control Panel Assembly on page 4-29).
8. Remove the Bypass Tray Assembly (REP 3.5 Bypass Tray Assembly on page 4-73).
9. Remove the Bypass Tray Cover (REP 3.3 Bypass Tray Cover Assembly/ Exit 1 Cover/ Exit 2 Cover on
page 4-71).
10. Remove the Front Cover Assembly (REP 1.15 Front Cover Assembly on page 4-35).

Xerox Phaser 7100 Specifications

General

Brand	Xerox
Model	Phaser 7100
Category	Printer
Language	English