Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-367
116-742 Max Logo Registered
The logo data cannot be registered due to the restriction on the number of logos.
Applicable Fault Code
• 116-742: <Logo registration error> The logo data cannot be registered due to the restriction on
the no. of logos.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
116-743 Out of Buffer Area-Form/ Logo REGI ERR
<Form/logo cannot be registered (insufficient area) The received data (form/logo) exceeded the
registered buffer size.
Applicable Fault Code
• 116-743: <Form/logo size overflow> The received data (form/logo) exceeded the registered buffer
size.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. After checking the registered logos using the Operation Panel utility, delete the unnecessary logos.
Or, delete the unnecessary logos with Print Command.
Troubleshooting Procedure
Step Actions and Questions
1. Increase the size of the Form Registration Area using the Operation Panel.
Or, install the HD.
To Next Page
Loading...
Need help?
General