Service Parts Disassembly
Phaser 7100 Service Manual Xerox Internal Use Only4-152
REP 8.6 Dispense Motor Assembly
PL 8.1.15
CAUTION: Do not expose the Imaging Unit to light for more than 5 minutes. Cover the Imaging
Unit to avoid damage. Do not touch the surface of the Imaging Unit.
Note: The Dispense Motor Assembly removal procedure applies for all 4 Dispense Motor Assembly
(Y/ M/ C/ K).
1. Remove the Imaging Unit (Y/ M/ C/ K) (REP 6.0 Imaging Unit (Y/ M/ C/ K) on page 4-121).
2. Remove the Toner Cartridge (Y/ M/ C/ K) (REP 8.0 Toner Cartridge Assembly (Y/ M/ C/ K) on
page 4-136).
3. Remove Tray 1.
4. Remove the I/P PWB Cover Assembly (REP 1.5 Image Processor (I/P) PWB Cover Assembly on
page 4-19).
5. Remove the Rear Cover (REP 1.6 Rear Cover on page 4-20).
6. Remove the Right Side Cover (REP 1.11 Right Side Cover on page 4-27).
7. Remove the Left Side Cover (REP 1.10 Left Side Cover on page 4-25).
8. Remove the Toner Cartridge Cover Assembly (REP 1.9 Toner Cartridge Cover Assembly on
page 4-24).
9. Remove the Toner Cartridge Hinge Cover (REP 1.7 Toner Cartridge Hinge Cover on page 4-21).
10. Remove the Right Feeder Cover (REP 2.3 Right Feeder Cover on page 4-40).
11. Remove the Cam Cover (REP 9.7 Cam Cover on page 4-170).
12. Remove the IBT Retract Cam Assembly (REP 9.6 IBT Retract Cam Assembly on page 4-168).
13. Remove the Right Imaging Unit Guide Assembly (REP 6.1 Right Imaging Unit Guide Assembly on
page 4-123).
14. Remove the Left Imaging Unit Guide Assembly (REP 6.5 Left Imaging Unit Guide Assembly on
page 4-129).
15. Remove the Developer Housing Assembly (Y/ M/ C/ K) (REP 8.1 Developer Housing Assembly (Y/
M/ C/ K) on page 4-137).
16. For Yellow and Magenta Dispense Motor Assemblies, remove the MCU Plate (REP 8.7 MCU Plate
on page 4-154).
To Next Page
Loading...
Need help?
General