Xerox Phaser 7100 Service Manual

Image Quality
Phaser 7100 Service Manual Xerox Internal Use Only3-28
4. Check the Developer Unit installation.
Is the Developer Housing Assembly (Y/ M/ C/ K)
installed properly, with no contamination at the
high voltage terminal?
Go to step 5. Clean the high voltage
terminal.
Reinstall the Developer
Housing Assembly
(REP 8.1 Developer
Housing Assembly (Y/
M/ C/ K) on
page 4-137).
5. Check the Developer Unit.
Is the Developer Housing Assembly (Y/ M/ C/ K)
normal, without any contamination, damage, or
wear and tear?
Go to step 6. Replace the Developer
Housing Assembly
(REP 8.1 Developer
Housing Assembly (Y/
M/ C/ K) on
page 4-137).
6. Check the HVPS1 PWB connector.
Is the connector seated securely?
Go to step 7. Connect the wiring
harness connector.
7. Check the Intermediate Transfer Belt.
Is the IBT Unit normal, without contamination,
damage, or wear and tear?
Go to step 8. Replace the IBT Unit
(REP 9.10 IBT Unit on
page 4-177).
8. Check the IBT Unit.
Is the high voltage terminal of the IBT Unit free
from contamination and it is in proper contact
with the Spring?
Go to step 9. Clean the high
voltage terminal.
Reinstall the IBT Unit
(REP 9.10 IBT Unit on
page 4-177).
9. Replace the IBT Unit (REP 9.10 IBT Unit on
page 4-177).
Does the error persist?
Go to step 10. Troubleshooting
complete.
10. Check the HVPS2 PWB connectors.
Are the connectors seated securely?
Replace the HVPS2
PWB (REP 12.1 HVPS2
PWB on page 4-202).
Connect the wiring
harness connectors.
Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Xerox Phaser 7100 Specifications

General

Brand	Xerox
Model	Phaser 7100
Category	Printer
Language	English